Category Archives: Arizona Department of Transportation

I-17 southbound ramp to be closed at JW Powell Boulevard

Posted on by

adot-logo3FLAGSTAFF – Access to the I-17 southbound off-ramp at Exit 337 (JW Powell Boulevard) will be closed on Monday, Oct. 20, from 7 a.m. to 5 p.m., to install a temporary concrete barrier in preparation for new ramp construction. This work is part of the intersection improvement project currently underway which includes a new roundabout and realignment of SR 89A/Beulah Boulevard.

The recommended detour for southbound I-17 connections to the Flagstaff Airport and to SR 89A is to continue southbound on I-17 past Exit 337, then exit at Kachina Trail/Mountainaire Road (Exit 333). Detour signage will be in place to assist travel in the area.

Paving to occur at Route 66 and Switzer Canyon intersection in Flagstaff

Posted on by

adot-logo3FLAGSTAFF – Travelers heading east- and westbound through Flagstaff on Route 66 (Milton Ave.) can expect delays Monday and Tuesday Oct. 20 and Oct. 21, between 6 a.m. to 2 p.m., including work Tuesday night from 8 p.m. to 5 a.m. while maintenance crews mill and pave the intersection following repairs to the water main. Traffic northbound on Switzer Canyon Road will also experience restrictions during the repair and paving activity. Travel lanes will be reduced to one lane in each direction at the intersection while construction is underway. Please exercise caution while driving in and around the construction zone.

Pavement Markings to be replaced on I-17 just north of SR 179 Junction beginning Columbus Day

Posted on by

adot-logo3One lane for northbound traffic on I-17 will be temporarily closed with reduced travel speeds for a three mile segment just north of the SR 179 junction beginning Monday, Oct. 13. The lane reduction is required to allow for removal and installation of new pavement markers which provide greater visibility during weather events and are more durable under heavy traffic.

The marking replacement operation will continue weekly Monday through Thursday from 6 a.m. to 6 p.m., and is expected to be completed mid-November. During construction, drivers are asked to allow for extra travel time, exercise caution and observe reduced speeds within the construction zone.

Overnight work on SR 89 between Prescott and Chino Valley resumes next week

Posted on by

adot-logo3Paving of a temporary detour and a section of the new roadway on State Route 89 between Prescott and Chino Valley (milepost 323) will require delays of up to 15 minutes at a time next week.

Overnight work will begin on Monday, Oct. 13 and continue through Wednesday, Oct. 15 between 7 p.m. and 5 a.m. each day. Traffic will be required to stop intermittently during work hours and guided through the work zone with flaggers.

The work zone will be clearly marked by temporary barricades and signage. ADOT advises drivers to allow additional time to reach their destinations and to proceed through the work zone with caution, comply with the reduced speed limit, and be alert for construction equipment and personnel.

Lane restrictions on SR 260 for drainage repair

Posted on by

Motorists traveling on State Route 260, approximately 18 miles east of Camp Verde need to be aware that maintenance crews are repairing shoulders due to recent rain events between mileposts 238 and 251.

Drivers can expect alternating lane restrictions on the two-lane roadway between 7 a.m. and 5 p.m. Monday through Thursday, through Oct. 23. Delays of up to 15 minutes are expected.
adot-logo-03a
The speed limit through the work zones will be reduced to 45 mph during work hours.

The work zone will be clearly marked by temporary barricades and signage. ADOT advises drivers to allow additional time to reach their destinations and to proceed through the work zone with caution, comply with the reduced speed limit, and be alert for construction equipment and personnel.

Construction of retaining wall on US 60 in Wickenburg begins mid-October

Posted on by

PRESCOTT – The Arizona Department of Transportation will begin a slope stabilization project with the construction of a new retaining wall on the north side of US 60 from Lazy Fox Drive to Falcon Road in Wickenburg.

The work will begin on Wednesday, Oct. 15 and will require a 24-hour single-lane restriction westbound and the closure of the multi-use path through the work zone (approximately 500 feet) for the next three months.

Work hours will be Monday through Thursday from 7 a.m. to 6 p.m. with an anticipated completion date by the end of February 2015.

adot-logo3Motorists should expect minimal delays throughout the project. The $247,000 project includes the construction of a new retaining wall and reconstruction of the multi-use path along the north side of the roadway plus handrail.

ADOT advises drivers to proceed through the work zone with caution, slow down, and be alert for construction equipment and personnel.

Lane restrictions on Interstate 17 this week

Posted on by

adot-logo-03aThe Arizona Department of Transportation has scheduled guardrail repair this week on Interstate 17 in both directions between Sunset Point and New River. Work will occur until 7 p.m. today and continue through Thursday, Oct. 9. Work hours are 7 a.m. to 7 p.m. each day.

The work between mileposts 234 and 253 will require alternating lane restrictions in both directions and intermittent shoulder closures during work hours to provide a safe work zone for maintenance crews. No delays are expected.

The speed limit through the work zones will be reduced to 45 mph during work hours.

ADOT works to inform the public about planned highway restrictions, but there is a possibility that unscheduled closures or restrictions may occur. Weather can also affect a project schedule.

Roundabout work on US 93 at Wickenburg Ranch scheduled for next three months

Posted on by

adot-logo3PRESCOTT – For the next three months crews will be constructing a new roundabout on US 93 at milepost 194 near Wickenburg (approximately three-quarters of a mile southeast of the SR 89/US 93 junction) as part of the Wickenburg Ranch development.

Work is scheduled to begin this week with placement of temporary construction signage and concrete barrier installation that will require a shoulder closure through the work zone. Crews will be working seven days a week during the day between 6 a.m. and 6 p.m. with some intermittent night work possible Sunday to Thursday nights between 7 p.m. and 5 a.m.

Initially, drivers will not be affected with work scheduled behind the concrete barrier however drivers could be limited to one lane through the work zone with minimal delays within the next two weeks. A 12-foot width restriction and a shoulder closure will be in effect as soon as concrete barrier is installed.

Flaggers will direct traffic in alternating directions using the single lane that is open. The speed limit will be reduced to 45 mph.

The work zone will be clearly marked by temporary barricades and signage. ADOT advises drivers to allow additional time to reach their destinations and to proceed through the work zone with caution, comply with the reduced speed limit, and be alert for construction equipment and personnel.

This project is under permit with the Arizona Department of Transportation and is scheduled to be complete by the middle of January 2015.

Seasonal and storm repairs on SR 89A through Oak Creek underway

Posted on by

adot-logo-03aMotorists travelling on SR 89A through Oak Creek Canyon may experience delays as maintenance crews clear debris and repair drainage facilities as part of ADOT storm response operations. Cleanup work will occur from the Midgley Bridge just north of Sedona and continue through the area switchbacks.

While work is underway please prepare for delays and plan accordingly. Operations will be underway weekly from 7 a.m. To 4 p.m. Monday-Thursday and is anticipated to be completed by Oct. 16.

New specialty license plates now available

Posted on by

new-vanity-platePHOENIX – Three new specialty license plates to help personalize and customize your vehicle are now available for purchase from the Arizona Department of Transportation Motor Vehicle Division.

The new plates include a Girls Youth Organization plate to support the Girl Scouts; an Arizona Motorsports Commemorative plate for Phoenix International Raceway; and a redesigned Phoenix Suns plate.

Like many of Arizona’s specialty license plates, these three support specific charities. Funds raised by the Girls Youth Organization license plate will provide enriching experiences in Arizona’s Girl Scouts program, such as extraordinary field trips, sports skill-building clinics, community service projects and cultural exchanges.

“We are thrilled to have a Girl Scout license plate. It’s a great way for parents and alumnae to show their support and $17 of the proceeds goes directly back to local Girl Scouts. Each license plate is actually an investment in Arizona girls and our future,” said Tamara Woodbury, CEO of Girl Scouts–Arizona Cactus-Pine Council.

Funds raised by the Phoenix International Raceway license plate will go to Motorsports Charities to provide resources and charitable support for children through education, medical treatment, dream experiences and volunteerism.

“We are thrilled to be able to help race fans show their NASCAR pride with this license plate and to support a great cause in the process,” said PIR President Bryan R. Sperber. “The idea for a custom plate was spurred by fan requests, so we are proud to make this available to them. The plates also create a wonderful legacy from our 50th Anniversary that will last well beyond this year.”

The redesigned Phoenix Suns plate will continue to support Phoenix Suns Charities for youth education and development, college scholarship programs and community development.

The license plates have an annual fee of $25 for a non-personalized plate and $50 for a personalized plate, with $17 going to support the charities. Vehicle owners can purchase the new plates at any MVD or Authorized Third Party office location or online at ServiceArizona.com.

Because the Phoenix Suns license plate is a new design, anyone with the current plate design can request the new plate design for a $5 replacement fee. However, the redesigned plate has six characters instead of the seven that are on the current Suns plate. So those with a personalized Suns plate with seven characters would not be able to transfer their personalization to the new design. They can reapply for the new design, but would have to start the application process from the beginning.

The older, original Phoenix Suns license plate design is still valid for use.

There are no special requirements to get the license plates. The plates are also available with a disability symbol.